Factory Welded Loops

It is now possible to put factory welded loops on all MONIC Fly Lines. This simple procedure can be done even on the river if need be.

What's Needed.....

You will need a lighter, your MONIC Fly Line, and MONIC Welding Shrink Tubing.

First Step....

Thread fly line all the way through welding shrink tubing.

Second Step....

Feed fly line back into tubing, forming loop. Size according to preference.

Third Step....

With fly line under tension (this is a key point), hold loop and begin to melt tubing and fly line with the blue part of the flame. When melting keep flame moving at all times. Start on one side of line and then go back over on the other side of the line. Please note that too much heat will completely melt fly line and ruin it. You want to aply just enough heat to shrink tubing.

Finished....

Allow to cool and loop onto backing or leader.